Roto/Blow Molding
Rotational molded products from Alpha Systems’ state-of-the-art machines utilize new product technologies for best quality. The result is finished products of a much higher quality than other processes. Our roto molded tanks meet standards specified by both USA and Canadian listing agencies. Our rotational molding capabilities can produce finished parts as large as 100 gallons.
Some of the rotational molded products Alpha manufactures:
- Fresh Water Tanks
- Holding Tanks – Black and Gray
- Storage Compartment Liners
- Boat Seating
- Custom Molding
Alpha’s revolutionary blow molded fresh water and waste water holding tanks are the most reliable in the industry. The uniform thickness of the tanks makes them exceptionally durable. These tanks meet standards specified by both USA and Canadian listing agencies. Our blow molding capabilities include three presses that can produce finished parts as large as 40 pounds.
Some of the blow molded products Alpha manufactures:
- Fresh Water Tanks
- Gray Water Holding Tanks
- Black Water Holding Tanks
- Custom Molding
The tank will arrive with a drain (ABS so you can begin to glue to the tank draining system). This is called a HUB Drain or outlet. Most tanks will come with the sensors/probes for the monitoring system installed. Don’t fear if the tank arrives without them, they are included in the holding tank kit available for purchase.
The tank comes complete with what you need to hook up to your drain system, but you will need a kit to customize your inlets to your specific unit. (Part # VBKITH)
The VBKITH kit will come with everything you need to make your tank a black water or grey water tank as well as probes. Installation instructions for the rubber grommets are also included in the kit. The instructions will tell you what size hole you need for each grommet. The hole size is critical – be sure to verify the hole size before you drill your tank.
The kit includes:
- (1) 3” grommet
- (1) 3” barbed coupler
- (1) 1.5” grommet
- (1) 1.5” barbed coupler
- (6) grommet style probe sensors
- Installation Instructions
No, sealant is not necessary if the grommet is installed properly. You may use butyl caulk if you prefer. This can be purchased at your local home improvement store.
Yes, the part number is VB113HORKIT. This includes a 3” hub and o-ring.
There is no glue that will permanently secure your fittings to your tank. You will need to supply a print to the manufacturer with placement and size of the fittings you need.
This is not glue but is the actual tank and fitting being melted together via the spin weld process.
Our tanks are listed with TEI and the listing certifies them to CSA Z240.3.2 and IAPMO TS 4. These two standards require the use of NSF61 material.